🔍
Frigidaire Washing Machine ⛔ Unplug Now

Frigidaire Washing Machine Error Code E13

Frigidaire washer error code E13: Water leak in tub or pressure switch hose.

Last reviewed: Last updated:

Methodology: We combine manufacturer references with recurring service patterns, then review for safe, step-by-step repair guidance.

Sources: Manufacturer fault-code sheets, service manuals, and recurring field-repair patterns.

Limits: Guidance is informational and may not match every model-year or revision. Confirm with the official manual and diagnostics before replacing parts. For safety-critical or electrical work, use a qualified technician.

Should I unplug it?
⛔ Yes — unplug now
Stop using immediately — water and electricity are dangerous. Unplug before inspecting.
Can I fix it myself?
Technician Recommended
Part: Door boot / tub pressure hose / drain hose / dispenser hose
How much will it cost?
DIY: $50–$200 (if hose/seal)
Technician: $150–$500
⏱ 30–120 min

What Does Error E13 Mean on Your Frigidaire Washing Machine?

Frigidaire washer error code E13: Water leak in tub or pressure switch hose.

What typically fails: Door boot / tub pressure hose / drain hose / dispenser hose

What You're Probably Seeing

What to Try First

  1. 1 Press cancel and stop the cycle if water is still entering the tub
  2. 2 Shut off the hot and cold supply valves, then unplug the washer before inspecting it
  3. 3 Look for water coming from the door boot, dispenser, drain hose, or the small pressure hose that runs to the tub
  4. 4 Reseat any loose hose clamps and replace a split pressure hose or torn door boot before using the washer again
  5. 5 If you cannot find the leak source quickly, leave the washer off and book service
🛠️ You'll need: Screwdriver set, Towels, Flashlight · Time: 30–120 min
💡 Try this first: Unplug the appliance for 60 seconds, then plug back in. This resets the control board and clears many temporary faults.

Questions People Also Ask

What does Frigidaire Washing Machine error code E13 mean? ▼
Error code E13 on a Frigidaire Washing Machine means: Water leak in tub or pressure switch hose. The appliance detected this condition and has stopped or limited operation to prevent further damage.
How do I fix Frigidaire Washing Machine error code E13? ▼
Start by stopping the cycle, shutting off the water supply, and unplugging the washer. If error E13 returns, inspect the pressure hose, door boot, drain hose, and dispenser path for an active leak before using the washer again.
Is it safe to use my Frigidaire Washing Machine with error code E13? ▼
No. E13 points to a water leak, so leave the washer off until the leak source is found and corrected.

More Frigidaire Washing Machine Codes

All Frigidaire washing machine error codes → All Frigidaire appliance codes →

Was this page helpful?

Rate the helpfulness of this page