πŸ”
caution Severity β€” Powertrain OBD-II DTC

P0171 on Nissan Rogue

Last reviewed: Last updated:

Methodology: Reviewed against the SAE J2012 generic DTC definition and NHTSA owner-complaint patterns, then scoped to Nissan Rogue context without treating complaints as confirmed diagnoses.

Sources: SAE/OBD-II definitions, manufacturer service information, and public reliability reports (including NHTSA where applicable).

Limits: Guidance is informational and may not match every model-year or revision. Confirm with the official manual and diagnostics before replacing parts. For safety-critical or electrical work, use a qualified technician.

⚑ Quick Summary

Severity
caution
DIY Level
Moderate
Repair Cost
Urgency
Fix when convenient

🚨 Symptoms of P0171

β–Έ Warning light or diagnostic trouble code is stored
β–Έ Rough idle, surging, hesitation, or poor fuel economy may occur
β–Έ Lean or rich fuel-trim readings may appear in scan-tool live data
β–Έ Vehicle may fail an emissions or safety inspection until the code is resolved and monitors reset

πŸ” Common Causes of P0171

HIGH
Vacuum leak, intake duct leak, MAF/MAP sensor contamination, oxygen sensor feedback issue, or exhaust leak
MED
Wiring, connector, low battery voltage, or software issue affecting sensor readings
MED
Fuel pressure, injector, or mechanical condition that changes air-fuel ratio under load

❓ Frequently Asked Questions

β–Ύ
β–Ύ

Browse Codes by System

Was this page helpful?

Rate the helpfulness of this page

Disclaimer: This information is for educational purposes only. It is not intended as repair advice and we are not responsible for any actions you take on any vehicle. Always consult a qualified mechanic for diagnosis and repair. Repair costs shown are estimates and may vary by location, vehicle, and shop.