Whirlpool
WTW500CM** (V22AAF50(3B))
Washing Machine
Whirlpool WTW500CM** (V22AAF50(3B)) — Error Code F3E1
Whirlpool WTW500CM** (V22AAF50(3B)) error code F3E1: Pressure switch / water level sensor failure.
Last reviewed:
Last updated:
Methodology: We combine manufacturer references with recurring service patterns, then review for safe, step-by-step repair guidance.
Sources: Manufacturer fault-code sheets, service manuals, and recurring field-repair patterns.
Limits: Guidance is informational and may not match every model-year or revision. Confirm with the official manual and diagnostics before replacing parts. For safety-critical or electrical work, use a qualified technician.
Looking for the full diagnosis and repair guide? View complete Whirlpool Washing Machine error code F3E1 guide →
Repair guidance: the symptoms and steps below come from the canonical Whirlpool Washing Machine F3E1 guide and apply to WTW500CM** (V22AAF50(3B)) unless your manual says otherwise.
Symptoms on WTW500CM** (V22AAF50(3B))
- ⚠️ Error code displayed
- ⚠️ Machine stops mid-cycle
- ⚠️ Cycle won't complete
How to Fix Error F3E1 on WTW500CM** (V22AAF50(3B))
- 1 Unplug the washing machine for 60 seconds then plug back in — this resets the control board and clears many temporary faults
- 2 Test the sensor with a multimeter — check resistance against the spec in the service manual
- 3 Inspect the sensor's wiring harness for corrosion or loose connector
- 4 Replace the sensor if out of spec ($10–$50 part)
- 5 If the error persists after basic troubleshooting, contact a qualified appliance technician
🛠️ You'll need: Multimeter, Screwdriver set
· Time: 20–45 min
Questions People Also Ask for Error F3E1
What does Whirlpool Washing Machine error code F3E1 mean? ▼
Error code F3E1 on a Whirlpool Washing Machine means: Pressure switch / water level sensor failure. The appliance detected this condition and has stopped or limited operation to prevent further damage.
How do I fix Whirlpool Washing Machine error code F3E1? ▼
Power-cycle the washer, then inspect the pressure hose for cracks or soap buildup and test the water level sensor. If the hose and sensor test good, check the harness to the main control.
Is it safe to use my Whirlpool Washing Machine with error code F3E1? ▼
It depends on the cause. Most F3E1 errors mean the appliance has stopped itself as a safety measure. Check the 'Should I unplug it?' section above for specific guidance on this error.