Whirlpool
WFW6720R**
Washing Machine
Whirlpool WFW6720R** — Error Code F9E1
Whirlpool WFW6720R** error code F9E1: Drain pump failure — water not draining.
Last reviewed:
Last updated:
Methodology: We combine manufacturer references with recurring service patterns, then review for safe, step-by-step repair guidance.
Sources: Manufacturer fault-code sheets, service manuals, and recurring field-repair patterns.
Limits: Guidance is informational and may not match every model-year or revision. Confirm with the official manual and diagnostics before replacing parts. For safety-critical or electrical work, use a qualified technician.
Looking for the full diagnosis and repair guide? View complete Whirlpool Washing Machine error code F9E1 guide →
Repair guidance: the symptoms and steps below come from the canonical Whirlpool Washing Machine F9E1 guide and apply to WFW6720R** unless your manual says otherwise.
Symptoms on WFW6720R**
- ⚠️ Water left in drum after cycle
- ⚠️ Machine stops during spin
- ⚠️ Wet clothes after full cycle
How to Fix Error F9E1 on WFW6720R**
- 1 Unplug the washing machine for 60 seconds then plug back in — this resets the control board and clears many temporary faults
- 2 Verify the drain hose is not pushed too far into the standpipe and has not been taped airtight to the drain pipe
- 3 Inspect the drain hose for kinks, clogs, crushed sections, or a blocked utility sink/drainpipe
- 4 Check and clean the drain pump filter if your model provides owner access
- 5 Test the drain pump and wiring if the washer still hums or times out without moving water
- 6 If the error persists after basic troubleshooting, contact a qualified appliance technician
🛠️ You'll need: Screwdriver set, Bucket, Wet/dry vacuum
· Time: 20–45 min
Questions People Also Ask for Error F9E1
What does Whirlpool Washing Machine error code F9E1 mean? ▼
Error code F9E1 on a Whirlpool Washing Machine means: Drain pump failure — water not draining. The appliance detected this condition and has stopped or limited operation to prevent further damage.
How do I fix Whirlpool Washing Machine error code F9E1? ▼
Start by cleaning the pump filter and checking the hose for a clog. If the hose is clear and the pump still hums without moving water, test or replace the drain pump.
Is it safe to use my Whirlpool Washing Machine with error code F9E1? ▼
It depends on the cause. Most F9E1 errors mean the appliance has stopped itself as a safety measure. Check the 'Should I unplug it?' section above for specific guidance on this error.